Unitary Duct Split Unitary Duct Split
7
between holes and see Fig.3 for the installation of the expansion bolt.
Fig.3
Fig.4
Install the hanger on the indoor unit, as shown n Fig.4.
Install the indoor unit on the ceiling, as shown in Fig.5.
Fig.5
CUATION
！
①
.Prior to the installation, please make a good preparation for all piping
(refrigerant pipe, drain pipe) and wiring (wires of the wired controller, wires between the
indoor and outdoor unit) of the indoor unit to make the further installation much easier.
②
.If there is an opening in the ceiling, it is better to reinforce it to keep it flat and
To Next Page
Loading...
