Gree GMV-120WM/B-F

GMV5 D.C INVERTER MULTI VRF SERVICE MANUAL
326
2.1.5. Software
2.1.5.1 List of Parts
Parts of Gree CAC Remote Monitoring System
Part
Quantity
Supply Range
Purpose
Disk
1
SC
Used for installing Gree CAC Remote Monitoring
System on a PC
Installation
guide
1
SC
Providing instruction on the installation of Gree CAC
Remote Monitoring System
2.1.5.2 Preliminary Check
Check whether the Modbus gateway has been successfully debugged. If not, refer to the Technical
Service Manual of Modbus Gateway to debug the gateway.
Check whether the server has serial ports. If not, replace the server with one that has serial ports.
Check whether the server is configured with driver that can read disks. If not, replace the server with
one that has driver.
Check whether the server satisfies the following software configuration requirements.
Software configuration of Gree CAC Remote Monitoring System
Part Name
Min. Configuration
Recommended
Configuration
Internet Information Service (IIS)
manager
6.0 or later versions
6.0
MSMQ
/
/
Memory
1 GB or larger
2 GB or larger
Hardware
10 GB available
10 GB available
CPU
Main frequency: 2 GHz or higher
2 GHz or higher
OS
Windows Server 2003 SP2 or later
versions, Windows 7
Windows Server 2003
SP
NOTE:
Gree CAC Remote Monitoring System supports Windows Server 2003 SP2 or later versions
and Windows 7. Windows Server 2003 SP2 is recommended because the server can better provide
users with services in Windows Server 2003 SP2 system.
2.1.5.3 Software Setup
The software needs support of some Windows components in order to run; therefore, you should
install these components first before setup. The following installation flowchart shows you the basic
installation procedure. If some of the components have been available on your PC, you can skip
corresponding steps.