Gree GMV-ND07PLS/A-T(U) - Page 74

GREE Multi Variable Air Conditioners Indoor Unit
68
Parameter
Code
Parameter
Name
Parameter
Range
View Method
C04
Project
number
query of
master IDU
1-255: project
number
00: no master
IDU
Timer area: displays the project number of the master IDU/00.
C05
Historical
fault query
ingress of
IDU
Five historical
faults
Operation method:
In “C05” status, press the “MODE” button to enter the historical fault
query interface. Press " " or " " to switch the project number of IDU.
Press the “MODE” button to enter fault code query of the current IDU.
Press “ ” or “ ” to switch the fault SN. Press the “ENTER/CANCEL”
button to return to the upper-level menu.
Display mode:
Temperature area: displays the fault SN and fault code.
Timer area: displays the project number of IDU.
C10
Static
pressure
setting query
of ODU
00: 0 Pa
20: 20 Pa
50: 50 Pa
82: 82 Pa
Operation method:
In “C10” status, press the “MODE” button to enter static pressure
setting query of ODU. Press " " or " " to switch the ODU address.
Display mode:
Temperature area: displays the address of the current ODU.
Timer area: displays the static pressure setting value.
C13
Outdoor unit
network
number
query
1-255
Timer area: displays the network number of the current ODU.
C14
Temperature
query for
inlet-tube
temperature
sensor of
IDU
-9 to 99
Operation method:
In “C14” status, press the “MODE” button to enter inlet-tube
temperature sensor query of IDU. Press " " or " " to switch the IDU
SN.
Display mode:
Temperature area: displays the project number of the current IDU.
Timer area: displays the temperature value.
If the HBS network consists of only one IDU, the timer area directly
displays the temperature value in the “C14” interface.
No matter Fahrenheit or Centigrade remote signals are received, the
temperature is displayed in Centigrade.
When the wired controller displays the inlet-tube temperature after
receiving signals from the remote controller, the inlet-tube temperature
of the IDU that has the minimum project number in the HBS network is
displayed by default.
C15
Temperature
query for
outlet-tube
temperature
sensor of
IDU
-9 to 99
Operation method:
In “C15” status, press the “MODE” button to enter outlet temperature
sensor query of IDU. Press " " or " " to switch the IDU SN.
Display mode:
Temperature area: displays the project number of the current IDU.
Timer area: displays the temperature value.
If the HBS network consists of only one IDU, the timer area directly
displays the temperature value in the "C15" interface.
When the wired controller displays the outlet-tube temperature after
receiving signals from the remote controller, the inlet-tube temperature
of the IDU that has the minimum project number in the HBS network is
displayed by default.