Gree GMV-ND07PLS/A-T(U) - Super High Static Pressure Duct Type Indoor Unit

GREE Multi Variable Air Conditioners Indoor Unit
176
Pump
Step
Diagram
Operation Procedure
(6) Install and
screw the
water tray.

Use a screwdriver to screw the
water tray.
4.11 Super High Static Pressure Duct Type Indoor Unit
Note: The following steps are specific for GMV-ND24PHS/B-T(U) units. For other units, the assembly
and disassembly procedure is similar except the specifications of centrifugal fans and motors.
Motor and fan
Precondition: The power supply has been disconnected.
Step
Diagram
Operation Procedure
(1) Remove the
line
connecting to
the motor.

Use a screwdriver to unscrew
the electric box cover.

Remove from the master board
the line connecting to the
motor and remove the tie.
(2) Disassemble
the seal plate
and cover
plate.

Use a screwdriver to unscrew
the seal plate and cover plate
and then remove them.
(3) Remove the
grille.

Use a screwdriver to unscrew
the cover plate component.
(4) Remove the
centrifugal
fan.

Use a screwdriver to unscrew
the front volute casing and
then remove the volute casing.