Multi VRF Floor Standing Indoor Unit
18
6.2.3 Setting of Light ON/OFF Function
(1) Light ON/OFF Function: can set the ON and OFF of light for display
panel.
(2) Under power-on or power-off status, press “Light” button to turn on and
turn off the light of display panel.
(3) When the light of display panel is turned off, press the other buttons
other than “Light” button, the light on display panel will be turned off
after 5 seconds.
6.2.4 Temperature Setting
Press “▼” or “▲” buttons under power-on status, the set temperature will be
increased or decreased at 1°C each time; when long press the buttons, the
temperature will be increased or decreased at 1°C every 0.3 seconds. The
temperature setting range is: 16°C
～
30°C.
NOTES!
Under auto mode, the temperature cannot be set through pressing “▼” or
“▲” buttons.
6.2.5 Function Setting
Press “Function” button under power-on or power-off status, it can enter into
function setting status. Under function setting status, press “ON/OFF” button or
without pressing any buttons for consecutive 5 seconds, it will quit the function
setting status.
(1) Up and down swing function settings.
Press “Function” button under power-on status to switch to up and down
swing function, when “ ” icon flickers, press “▲” or “▼” button to start up or
cancel the up and down swing function. If “
” is on it means the function has
been started up; if “
” icon is off it means the function has been canceled.
(2) Left and right swing function settings.
Press “Function” button under power-on status to switch to left and right
swing function, when “
” flickers, press “▲” or “▼” button to start up or cancel
To Next Page
Loading...
Need help?
General
