DC Inverter Multi
VRF Service Manual
33
CONTROL
displays indoor ambient temperature, if received the other remote control signal, it will display presetting temperature, 5s
later, will back to display the ambient temperature.(This function is applicable to partial of models)
TURBO
In Cool or Heat mode, press this buttoncan turn on or turn off the Turbo function.After turned on the Turbo function,
itssignal will be displayed. When switchingthe mode or changing fan speed, thisfunction will be canceled automatically.
Press this button, to set up swing angle,which circularly changes as below:
This is an universal use remote controller. If remote controller sends the following threekinds of status that the swing
status of mainunit will be:
When the guide louver start to swing up anddown, if turn off the Swing, the air guide louverwill stop at current
position.
which indicates the guide louver swings upand down between that all ve positions.
TIMER ON
Timer On setting: Signal “ON” will blink and display, signal will conceal, the numerical section will become the
timer on setting status. During 5 seconds blink, by pressing + or - button to adjust the time value of numerical section,
every press of that button, the value will be increased or decreased 1 minute. Hold pressing + or - button, 2 seconds later, it
quickly change, the way of change is: During the initial 2.5 seconds, ten numbers change in the one place of minute, then
the one place is constant, ten numbers change in the tens place of minute at 2.5 seconds speed and carry. During 5s blink,
press the Timer button, the timer setting succeeds. The Timer On has been set up, repress the timer On button, the Timer
On will be canceled. Before setting the Timer, please adjust the Clock to the current actual time.
TIMER OFF
Once press this key to enter into TIMER OFF setup, in which casethe TIMER OFF icon will blink. The method of
setting is the same TIMER OFFas for TIMER ON.
2.2.2 Guide for operation- General operation
ON/OFF
MODE
FAN
CLOCK
BLOW
TURBO
SLEEP
LIGHT
TIMER OFF
TEMP
TIMER ON
1
3
4
2
5
1. After powered on, press ON/OFF button, the unit will start to run.(Note: When it is powered off, the guide louver
of main unit will close automatically.)
2.Press MODE button, select desired running mode, or press COOL or HEAT mode to enter into the corresponding
operation directly.
3.Pressing +or - button, to set the desired temperature. (It is unnecessary to set the temp. at AUTO mode.)
4. Pressing FAN button, set fan speed, can select AUTO FAN, LOW, MID and HIGH.
5. Pressing
button, to select the swing.
To Next Page
Loading...