DC Inverter Multi
VRF Service Manual
41
CONTROL
3.2.2 Dimension
92
60
35
92
24
46
11
24
Fig.3.2.2
3.2.3 Installation of Wired Controller
1 3 4 52
Fig.3.2.3
No. 1 2 3 4 5
Name Socket housing installed in wall Base plate of controller Screw M4X25 Control Panel Screw ST2.2X6.5
Notice for installation under the guidance of Fig�3�2�3
⑤ .
Cut off power supply before install the electrical components, it is forbidden to carry out the installation with
power on;
⑥ .
Get one end of the 4 core communication cable, put it through the rectangular hole on the base board on the wire
remote controller;
⑦ .
Hold the base board of controller on the wall, then x it to the wall with M4x25 screw;
⑧ .
Plug the 4 core communication cable into the slot on the wired remote controller, then x the controller panel
with base board together;
To Next Page
Loading...