10
Introduction for buttons on remote controller
"
+
"
or
"
-
"
button
3
● After each pressing of "+" or "-" button, it can increase or decrease set temper-
will change quickly. After reaching to your required time, loosen the button.
Temperature indicator on the unit will also change accordingly. (Temperature
can’t be adjusted under auto mode)
● Under TIMER ON, TIMER OFF or Clock setting, you can press "+"or "-" button to
adjust time. (Refer to TIMER button for details)
FAN button
4
Pressing this button can set fan speed circularly as: auto (AUTO), low( ),
medium( ), high( ).
Auto
Note:
●
low speed) according to ambient temperature.
● Fan speed under dry mode is low speed.
HEALTH SAVE button
7
6
5
HEALTH FUNCTION:
After pressing HEALTH button, remote controller will switch circularly as below:
"HEALTH"→"AIR"→"AIR HEA
(Not applicable for this unit)
(Not applicable for this unit)
LTH"→"no display"
●
When selecting "HEALTH" by remote controller, HEALTH function will be started up.
● When selecting "AIR" by remote controller, AIR function will be started up. (Not
● When selecting "AIR HEALTH", AIR and HEALTH function will be started up.
● When there’s no display on remote controller, AIR and HEALTH function will be
turned off.
applicable for this unit)
button
button
Note:
For preventing cold wind, after starting up heating mode, indoor fan will blow fan
after delaying 1-5minutes (Details time is decided by indoor ambient temperature)
Temperature setting range on remote controller: 16
℃
-30
℃
. Fan speed setting
range: auto, low speed, medium speed and high speed.
ature 1
℃
. Hold
"
+
"
or
"
-
"
button, 2 seconds later, set temperature on remote controller
Under AUTO Speed,air conditioner will adjust the fan speed (high, medium or
To Next Page
Loading...
