5
Press this button and the mode will circulate according to below sequence:
Cool→Dry→Fan→Heat Cool&Heat Unit only
Cool: Under this mode, cooling mode indicator is bright. Dual-8 nixie tube displays
set temperature. Temperature setting range is 16
°C
~30
°C
.
Dry: Under this mode, drying mode indicator is bright. Dual-8 nixie tube won’t
display.
Fan: Under this mode, the air conditioner only blow fan. Fan indicator is bright.
Dual-8 nixie tube won’t displa
Heat Cool&Heat Unit only : Under this mode, heating mode indicator is bright.
Dual-8 nixie tube displays set temperature. Temperature
setting range is 16°C~30°C.
y.
Mode button
3
Fan button
4
Timer
5
Press timer button to enter into timer setting mode. Under this mode, press " "
or " " button to adjust the timer setting. Timer setting will increase or decrease
0.5 hour by pressing " " or " " button within 10 hours, while timer setting will
+
+
-
-
Sleep
6
Operation Introduction for Control Panel
Press this button and the fan speed will circulate as “low spee d→ medium speed →
high speed→ auto fan”.
increase or decrease 1 hour by pressing "
+
-
" or " " button beyond 10 hours.
After timer setting is finished, the unit will display temperature if there’s no
operation for 5 seconds. If timer function is started up, the upper indicator will keep the
display status. Otherwise, it won’t be displayed. Under timer mode, press timer button
again to cancel timer mode.
Press sleep button to enter into sleep mode. If the controller operates at cooling
mode, after sleep mode is started up, preset temperature will increase by 1°C
within 1 hour ;preset temperature will increase by 2°C within 2 hours and then the
unit will operate at this temperature all the time;
Press sleep button to enter into sleep mode. If the controller operates at heating
mode, after sleep mode is started up, preset temperature will decrease by 1°C
within 1 hour ;preset temperature will decrease by 2°C within 2 hours and then the
unit will operate at this temperature all the time;
Sleep function is not available for fan mod e, drying mode and auto mode. If sleep
function is started up, the upper indicator will keep the display status. Otherwise, it
won’t be displayed.
To Next Page
Loading...
Need help?
General
