Gree GRS-CQ14Pd/NhG-M - Page 60

Unit Control
3.2.4.8 Remote Sensor
[Operation Instructions]
★
At the commissioning parameter setting page, by touching ―
Remote sensor
‖, the control panel will
access to the corresponding setting page, where it can be set to ―
With
‖ or ―
Without
‖.
[Notes]
●This setting will be memorized upon power failure.
●Only when ―
Remote sensor
‖ is set to ―
With
‖, the ―
Ctrl. State
‖ can be set to ―
T-room
‖.
3.2.4.9 Air Removal
[Operation Instructions]
★
At the commissioning parameter setting page, by touching ―
Air removal
‖, the control panel will access
to the corresponding setting page, where it can be set to ―
On
‖ or ―
Off
‖.
[Notes]
● This setting will be memorized upon power failure.
● This setting can be done only when the unit is turned off. And when it is set to ―
On
‖, the unit is not
allowed to be turned on.
3.2.4.10 Floor Debug
[Operation Instructions]
★
1. At the commissioning parameter setting page, by touching ―
Floor debug
‖, the control panel will
access to the corresponding setting page.
★
2. At the setting page, ―
Floor debug
‖, ―
Segments
‖, ―
Period 1 temp
‖, ―
Segment time
‖, and ―
ΔT of
segment
‖ can be set.
No.
Full Name
Displayed Name
Range
Default
Accuracy
1
Floor debug switch
Floor debug
On/Off
Off
/
2
Quantity of segments
Segments
1~10
1
1
3
Temperature of the first
Period 1 temp
25~35
℃
/
25
℃
/
1
℃