Super Free Match
Service Manual
CONTROL
47
mode or fan speed.
8) X-FAN:
Pressing X-FAN button in COOL or DRY mode, the icon
is displayed and the indoor fan will continue
operation for 10(2) minutes in order to dry the indoor unit even though you have turned off the unit. After
energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
9) ＋：
Presetting temperature can be increased. Press this button, the temperature can be set up, continuously press
this button and hold for two seconds, the relative contents can quickly change, until unhold this button and send
the order that the ℃(℉) signal will be displayed all the time. The temperature adjustment is unavailable under
the Auto mode, but the order can be sent if pressing this button. Temperature of Celsius degree setting: 16-30;
10) —：
Presetting temperature can be decreased. Press this button, the temperature can be button set up, continuously
press this button and hold for two seconds, the relative contents can quickly change, until unhold this button and
send the order that the ℃(℉) signal will be displayed all the time. The temperature adjustment is unavailable
under the Auto mode, but the order can be sent by if pressing this button.
11) QUIET:
Press this button, the Quiet status is under the Auto Quiet mode (display "
"signal ) and Quiet mode
(display "
" signal) and Quiet OFF (there is no signal of "
"displayed),after powered on, the Quiet OFF is
defaulted. Note: the Quiet function cannot be set up in Fan and Dry mode; Under the Quiet mode (Display "
"
Under the Quiet mode (Display "
" signal), the fan speed is not available.
12) SWING UP and DOWN
Press this button
to set up &down swing angle, which circularly changes as below:
This remote controller is universal. If it receives threes kinds of following status, the swing angle will remain
original.
If guide louver is stopped when it is swinging up and down, it will remain its present position.
indicates guide louver swings back and forth in the five places, as shown in the figure.
13) SWING LEFT and RIGHT
Press this button
to set left & right swing angle cycling as below:
14) TIMER OFF
One press this key to enter into TIMER OFF setup, in which case the TIMER OFF icon will blink. The
method of setting is the same as for TIMER ON.
To Next Page
Loading...
