Super Free Match
Service Manual
CONTROL
55
Time interval between two operations can’t exceed 5s. Otherwise, remote controller will exit the setting
status automatically.
11) TURBO
When pressing this button under cooling or heating mode, air conditioner will enter into quick cooling or
quick heating mode. The character of "TURBO" is displayed on remote controller. Press this button again to exit
turbo function and the character of "TURBO" will be disappeared on remote controller.
12) SLEEP
Press this button under cooling, heating mode can start up sleep function. "
" icon will be displayed on
remote controller. Press this button again to cancel sleep function. "
"icon on remote controller will be
displayed.
13) LIGHT
Press LIGHT button to turn on the display's light and press this button again to turn off the display's light. If
the light is turned on,
is displayed. If the light is turned off,
disappears.
3.5.2 Introduction for special Operation
1) Child lock function
Press ＋ and － buttons simultaneously can turn on or turn off child lock function. When child lock
function is started up, “
”icon will be displayed on it. If operate remote controller, “
” icon will flash three
times, while remote controller won’t send signal.
2) Switchover function for temperature display
After turning off the unit by remote controller, press "-" button and "MODE" button simultaneously to switch
between and °F .℃
3.5.3 Guide for General Operation
1) After putting through the power, press "ON/OFF " button on remote controller to turn on the air
conditioner.
2) Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3) Press "+" or "-" button to set your required temperature. (Temperature can’t be adjusted under auto
mode).
4) Press "FAN " button to set your required fan speed: auto, low, medium and
high speed.
5) Press "
" and "
" button to select fan blowing angle.
4 Smart Zone Controller (CE50-24/E)
4.1 General Introduction
To Next Page
Loading...
