Gree GWH07AWAXA-K6DNA1C

64
Technical Information
Service Manual
Buttons on remote controller
Introduction for icons on display
Set temperature
WiFi function
Sleep mode
Power limiting operation
X-FAN function
Left & right swing
Up & down swing
Child lock
Quiet
Indoor ambient temp.
Clock
Operation mode
Set time
TIMER ON / TIMER OFF
Turbo mode
Send signal
Auto mode
Cool mode
Dry mode
Fan mode
Heat mode
I feel
Set fan speed
Light
Introduction for buttons on remote controller
NOTE:
● This is a general use remote controller. It could be used for
the air conditioner with multifunction. For the functions which the
model doesn't have, if press the corresponding button on the
remote controller, the unit will keep the original running status.
● After putting through th e power, the air conditioner will give
out a sound. Power indicator "
" is ON. After that, you can
operate the air conditioner by using remote controller.
● Under on status, pressing the button on the remote controller,
the signal icon "
" on the display of remote controller will blink
once and the air conditioner will give out a "di" sound, which
means the signal has been sent to the air conditioner.
1.
button
Press this button to turn on the unit. Press this button again to
turn off the unit.
2. MODE button
Press this button to select your required operation mode.
AUTO COOL DRY FAN
HEAT
● When selecting auto mode, air conditioner will operate
automatically according to ambient temperature. Set temperature
can't be adjusted and will not be displayed as well. Press "FAN"
button can adjust fan speed. Press "SWING" button can adjust
fan blowing angle.
● When selecting cool mode, air conditioner will operate under
cool mode. Press "+" or "-" button to adjust set temperature.
Press "FAN" button to adjust fan speed. Press "SWING" button to
adjust fan blowing angle.
● When selecting dry mode, the air conditioner operates at low
speed under dry mode. Under dry mode, fan speed can't be
adjusted. Press "SWING" button to adjust fan blowing angle.
● When selecting fan mode, the air conditioner will only blow
fan, no cooling and no heating. Press "FAN" button to adjust fan
speed. Press "SWING" button to adjust fan blowing angle.
● When selecting heat mode, the air conditioner operates under
heat mode. Press "+" or "-" button to adjust set temperature.
Press "FAN" button to adjust fan speed. Press "SWING" button to
adjust fan blowing angle.
NOTE:
● For preventing cold air, after starting up heat mode, indoor
unit will delay 1~5 minutes to blow air (Actual delay time
depends on indoor ambient temperature).
6.2 Remote Controller Introduction for YAY1F1