116
Disassembly of Outdoor Unit, continued
24,000 & 30,000 btuh Warning - Wait 10 minutes aer power is disconnected before starting disassembly.
13. Before electric box sub-assy
Remove the screws holding the isolation sheet, loosen wire binds,
pull out the terminals, then li to remove the electric box sub-
assy.
14. Remove PFC electrical inductance
Remove the screws holding the PFC electrical inductance and
isolation sheet, then remove the PFC electrical inductance.
15. Remove 4-way valve sub-assy.
Remove all refrigerant from unit. Unsolder the tubing connect-
ing the compressor, then condenser assembly. Remove the 4-way
valve assembly.
16. Remove suction pipe sub-assy
Unsolder the joints connecting the suction pipe sub-assy, then
remove the assembly.
17. Remove liquid receiver
Remove the screws holding the isolation sheet and liquid receiver,
then li receiver out.
18. Remove isolation sheet assy.
Remove he screws holding the isolation sheet and condenser side
plate to remove the isolation sheet.
4-way valve
sub-assy
PFC electrical inductance
Electric box sub-assy
Isolation sheet assy.
Liquid receiver
Suction pipe sub-assy
To Next Page
Loading...