Gree SXVD200LCJ2/A-M - Page 140

AIR-TO-WATERHEATPUMP MAINTENANCE
134
② . Remove liquid
valve
·Loosen the bolts
fixing the liquid valve.
·Unsolder the pipe
connected to the
liquid valve [See
Fig.13]
Note：When welding,
the valve should be
covered by wet cloth
in order to avoid the
high temp damage.
Fig.13
9)Remove
compressor and
gas-liquid separator
· Remove the
connection wire of
compressor
· Unsolder the
suction pipe and
discharge pipe.
· Loosen the bolts
fixing the compressor
and remove the
compressor and
gas-liquid separator.
[See Fig.13]
Fig.14