Gree SXVD200LCJ2/A-M - Page 145

AIR-TO-WATERHEATPUMP MAINTENANCE
139
7) Remove the
motor
·Loosen the screws
fixing the motor
support. Remove the
motor support.
Loosen the wire of
motor, and pull it
through the hole.
Remove the motor.
[See Fig. 10]
Fig.10
8) Remove the
4-way valve
Remove the 4-way
valve
·Loosen the screws
fixing the coil of
4-way valve。
·Remove the coil of
4-way valve。
·Unsolder the tubes
connected to the
4-way valve.
·Remove the 4-way
valve.[See Fig.11]
Note：When welding,
the valve
should be
covered by
wet cloth in
order to avoid
the high
temp.
damage.
Fig.11