Gree U-match Series

U-Match Series DC Inverter Service Manual
112
Disassembly of evaporator
Remark: Make sure that the power supply is cut off and protect the copper tube and aluminum fin. If the time for
disassembly shall be long, put the copper tube under pressurized condition.
Step
Illustration
Handling Instruction
1. Disassembly of fixing
screws on the side panels of
evaporator
Disassemble the fastening screw
connecting left and right side panels on
the evaporator and the upper cover
plate. (As is shown in the arrows
direction in graph.)
2.Disassemble fastening
screws connecting
evaporator valve seal-plate
and joint flange
Disassemble the fastening screws on
the valve seal-plate and remove the
valve seal-plate. Disassemble the
fastening screws on the evaporators
joint flange. (As is shown in the graph,
box represents fastening screws on
seal-plates while circle the fastening
screws on joining flange.
3.Removal
of evaporator
Remove the evaporator. Removed
evaporator is shown in the graph.
4.2.2 Cassette-type Unit
Removal and Assembly of Fan Motor
Step
Illustration
Handling Instruction
1. Loosen the screws
fixing the water tray
Use screwdriver to loosen the screws
fixing the water tray.