Gree VERSATI SERIES - Page 31

28
Air to Water Heat Pump
Service Manual- Versati Series
DPOUSPM
Note:
a. In heating or cooling mode, it can select room temperature or leaving water temperature.
b. In sanitary heating mode, it can select sanitary water tank temperature and solar leaving water
temperature (solar kit is installed).
c. Room temperature setting is available when you have selected room temperature as control target.
d. Please refer function code 01.
e. ,QKHDWLQJPRGHLIZHDWKHUGHSHQGLQJPRGHLVDFWLYDWHG\RXFDQ¶WVHWWKHURRPWHPSHUDWXUHRURXWÀRZ
water temperature.
f. In heating mode , there are two Heating operation level:
1) high temperature cycle
2) low temperature cycle
g. Please refer to In function code 19.
3) Adjust desired temperature by pressing
button.
Note:
a.
: Increase 1°C or 1°F for each press.
b.
: Decrease 1°C or 1°F for each press.
4) Press
button to save the setting target temperature and return to the main
menu.
The range of the setting temperature (unit:
)
Temperature Mode Temperature range
2XWÀRZZDWHUWHPSHUDWXUH12)&8 cool 18~25(default:18)
2XWÀRZZDWHUWHPSHUDWXUH)&8 cool 7~25(default:7)
2XWÀRZZDWHUWHPSHUDWXUH Heat
high temperature cycle 25~55(default:40)
low temperature cycle 25-45(default:40)
Room temperature cool 18~30(default:20)
Room temperature heat 18~30(default:26)
Sanitary water tank temperature / 40~80(default:50)