Gree YAP1F - Preparation before Operation; Introduction of Operation Function

User’s Manual of Remote Controller
9
8
Set up&down swing status
9
X-FAN
Set X-FAN function
10
TIMER ON
Set timer on function
11
TIMER OFF
Set timer off function
12
SAVE
Set energy-saving function
13
SLEEP
Set sleep function
14
LIGHT
Set light function
15
CLOCK
Set clock of the system
16
I FEEL
Set I FEEL function
17
TEMP
Switch temperature displaying type on the unit’s display
2.1 Preparation before operation
When using the remote controller for the first time or after replacing the batteries,
please set the time of the system according to current time in the following steps:
(1).
Pressing CLOCK button, is blinking.
(2).
Pressing ▲ or ▼ button, the clock time will increase or decrease rapidly.
(3).
Press CLOCK button again to confirm the time and return to display current
time.
2.2 Introduction of operation function
(1).
Selecting operation mode
In unit on status, press MODE button to select operation mode in following
sequence:
 Floor heating, quick heating and heat supply modes are valid only with
specialized remote controller.
 If change to specialized remote controller, press MODE button and TEMP
button simultaneously, and then will blink for three times.
 If change to normal remote controller, press MODE button and TEMP button
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.