Gree YAP1F - Basic Operation Instructions; Replacing Batteries in Remote Controller and Notes

User’s Manual of Remote Controller
15
1).
Adjust set temperature to 30℃;
2).
Within 5 seconds, press ▼ button and then press ▲ button repeatedly for
three times;
 After finishing setting, “UC” is displayed on receiver light board for 5 seconds
and “MASTER” icon is displayed on wired controller.
(5).
Switching temperature scale
In unit off status, press MODE button and ▼ button simultaneously to switch
temperature scale between ℃ and ℉.
2.4 Basic operation instructions
(1).
When the main unit is energized, press ON/OFF button on the remote
controller to turn on the unit.
(2).
Press MODE button to select the desired operation mode.
(3).
Press ▲ or ▼ button to set the desired temperature (temperature setting is
not needed in auto mode).
(4).
Press FAN button to set fan speed in auto, low, medium and high speed.
2.5 Replacing batteries in remote controller and notes
(1).
Slightly press the place with OPEN, and then push out the back cover of
remote controller along the direction of arrow (as shown in Fig 3①).
(2).
Take out the original batteries (as shown in Fig 3②).
(3).
Place two 7# (AAA 1.5V) dry batteries, and make sure the position of
＋
polar
and
－
polar is correct (as shown in Fig 4③).
(4).
Reinstall the cover (as shown in Fig 4④)
Fig.3 Fig.4
Notes:
①
.
When replacing the batteries, do not use old or different types of batteries,
otherwise, it may cause malfunction.
②
.
When you won’t use the remote controller for a long time, please take out the
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.