User’s Manual of Remote Controller
11
In unit off status, press ▲ button and button to switch between simple
swing mode and fixed-angle swing mode. on the remote controller will be blinking
for 2 seconds during switching.
(5).
Setting quiet function
In unit on status, press button to adjust quiet status in following sequence:
: auto quiet function is on; : quiet function is on.
When quiet function is set, fan speed of indoor unit will be decreased to the lowest
speed in order to reduce the noise of indoor unit.
Notes:
①
.
Quiet function is not available in dry, fan and floor heating modes;
②
.
Quiet mode will be exited automatically when changing fan speed;
③
.
When turbo function is set, setting auto quiet function will cancel turbo
function.
(6).
Setting health function
In unit on status, press button to turn on or turn off health function.
1).
When is displayed, health function is on.
2).
When is not displayed, health function is off.
Health function is available when the unit is equipped with anion generator. When
health function is on, the anion generator will start operation, adsorbing the dusts and
killing the bacteria in the room.
(7).
Setting air function
Turning on air function:
1).
Press button until is blinking. Set temperature displaying zone
displays the last air function level.
2).
Press ▲/▼ button to adjust air function level. If there is no operation within 5
seconds, the setting will be exited automatically.
3).
Pressing button, is displayed and air function is turned on.
Press button until is disappeared, then air function is turned off.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
To Next Page
Loading...
