User’s Manual of Remote Controller
19
The light on the receiver light board will display present operation status. If you
want to turn off the light, please press LIGHT button. Press this button again to turn on
the light.
(7).
Viewing ambient temperature
In unit on status, receiver light board or wired controller is defaulted to display
setting temperature. Press TEMP button to view indoor or outdoor ambient
temperature.
is displayed, it means the displayed temperature is indoor ambient temperature.
When is displayed, it means the displayed temperature is outdoor ambient
temperature.
Ambient temperature displaying will be exited after 5s and then set temperature
will be displayed.
(8).
Setting X-FAN function
In cool or dry mode, press X-FAN button to set X-FAN function.
When is displayed, X-FAN function is on.
When is not displayed, X-FAN function is off.
When X-FAN function is on, the water on the evaporator will be blown away after
turning off the unit to avoid mildew.
(9).
Setting health function
In unit on status, press HEALTH button to set health function.
When is displayed, health function is on.
When is not displayed, health function is off.
Health function is available when the unit is equipped with anion generator. When
health function is on, the anion generator will start operation, adsorbing the dusts and
killing the bacteria in the room.
(10).
Setting sleep function
In unit on status, press SLEEP button to turn on or turn off sleep function.
When sleep function is on, the unit will operate according to a series of preset
sleep curves.
Sleep function can not be set in fan mode and auto mode. After entering sleep
mode, auto quiet function will be turned on automatically. You can also choose different
quiet statuses or turning off quiet function.
(11).
Setting I FEEL function
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
To Next Page
Loading...
