Fabra Hood Gravity Ventilator10
HARDWARE KIT # 916688
1/4 -20 x 1 in.
THREAD ROLLING SCREW
WITH WASHER
HARDWARE KIT # 916690
NO. 12 -11 x 3/8 in.
SHEET METAL SCREW WITH WASHER
(QTY OF 10 PER RIB)
High Wind - 4 Fabra hood B #471321
MALE RIB
DETAIL E
FEMALE RIB
DETAIL F - HOODS OVER 9 FEET
HOOD PANEL
(MALE RIB)
NO. 12 x 5/8 SHEET METAL SCREW
WITH SEALING WASHER
HOOD PANEL
(FEMALE RIB)
MALE RIB
FEMALE RIB
HOOD CLIP
HARDWARE KIT # 916689
NO. 12-14 x 1 in.
SELF TAPPING SCREW
HARDWARE KIT # 916691
NO. 12 -11 x 5/8 in.
SHEET METAL SCREW
(QTY OF 4 PER RIB)
Step 11 – Lift HOOD ASSEMBLY onto HOOD BASE
Lift completed hood assembly onto the hood base and attach the hood assembly to the hood support angles, using
3/8 x 3/4 inch bolt with 3/8 inch Nyloc nut (hardware kit # 809631) at each attachment point.
Step 12 – Tighten fasteners
Tighten all pivot bracket fasteners.
NOTE: There may be extra fasteners.
Figure 9
To Next Page
Loading...
