C3 Auto Whip Clad Cable Cutter
Greenlee Tools, Inc. 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
29
Service
The service replacement parts for the C3 Auto Whip
clad cable cutter and replacement instructions are
listed below.
All other service repairs must be done by a Greenlee
Factory Service Center. Contact 1.800.435.0786 or
factoryserv@emerson.com for any questions
you may have.
Disconnect power before servicing this tool.
Accidental start-up could cause serious injury.
Replacement of power cord must be done by a
Greenlee Factory Service Center.
Wear eye protection when servicing
this tool.
Failure to wear eye protection could
result in serious eye injury from ying
debris.
Wear protective gloves when
servicing this tool.
Failure to observe this warning could
result in serious injury.
Service Kits
KEY Part No. Description Qty.
A 52082254 Drivewheel 1
B 52082256 Blade, Circular (Cut off) 1
C 52082253 Screw, 3/8-16 LH x .70 Hex Cap 1
D 52082252 Washer (Cut Off) 1
E 52082255 Blade, Circular Saw (Notching) 1
F 52082251 Screw, 1/4-20 LH x 3/4 Hex Cap 1
G 52082250 Washer (Notching) 1
H 52082961 Bearing, Thrust 1.000 X .500 (Repair) 1
I 52084477 Lanyard, Cable 1
J 52084594 O-Ring, Encoder 1
To Next Page
Loading...
Need help?
General
