To Next PageTo Next PageWhat to do if my Greenlee Cutter tool will not start, and there is a constant light for 20 seconds when the trigger is released?
If your Greenlee Cutter tool won't start and a constant light appears for 20 seconds after releasing the trigger, the battery charge is likely low. Charge or replace the battery.
What to do if my Greenlee Cutter tool will stop, and there is a constant light for 20 seconds after the trigger is released?
If your Greenlee Cutter stops and shows a constant light for 20 seconds after you release the trigger, it indicates a low battery charge. You should charge or replace the battery.
Why is the LED glowing for 20 seconds on my Greenlee Cutter?
If the LED on your Greenlee Cutter glows for 20 seconds, it's likely because the battery charge is low. Charge or replace the battery.
What does it mean if there is a constant light for 20 seconds at the end of the cycle on my Greenlee Cutter?
A constant light for 20 seconds at the end of the cycle on your Greenlee Cutter indicates that the battery charge is low. Charge or replace the battery to resolve this.
What to do if my Greenlee Cutter is inoperative?
If your Greenlee Cutter is inoperative, it could be due to several reasons: * Dirt or contaminants in the tool head: Clean around the tool joints. * Worn or damaged tool components: Send the tool in for service. * Broken switch components: Send the tool in for service.
Why does my Greenlee Cutter motor run but the tool will not complete a cycle?
If the motor of your Greenlee Cutter runs but the tool doesn't complete a cycle, it could be due to: * Air in the hydraulic system: Pull the trigger and hold the retract button simultaneously for about 10 seconds, then try crimping again. If it still fails, send it in for service. * Cold oil: Warm the oil by pulling the trigger and holding the retract button simultaneously. Also, store the tool in a warm area.
What does Error Code 5 mean on my Greenlee Cutter?
Error Code 5 on your Greenlee Cutter indicates that the battery has no charge. You should charge or replace the battery.
What does Error Code 8 mean on my Greenlee Cutter?
Error Code 8 on your Greenlee Cutter means the battery is low. Charge or replace the battery.
General| Brand | Greenlee |
|---|---|
| Model | GATOR EK628LX |
| Category | Crimp tool |
| Language | English |
