EK628LX with CJB Bolt Cutting Jaw
52095141 REV 0012
© 2022 Greenlee Tools, Inc.
Transportation & Storage
Store tool, instructions, and accessories in the carry
case.
Remove battery before storing for more than 6 months.
Store battery with tool or on charging rack.
Store tool in a cool, dry place indoors or covered when
storing outside.
Statements
Model X—FCC ID: RFRMS42;
IC ID: 4957A-MS42
USA requirements:
Responsible party: Greenlee Tools, Inc. Rockford, IL
61109 USA
Note: This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference when the equipment is operated in
a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference
in which case the user will be required to correct the
interference at his own expense. This device complies
with the RF exposure SAR test exclusion requirements
for portable devices, if a minimum separation distance
is kept. However, the device shall be used in such a
manner that the potential for human contact during
normal operation is minimized.
Canada Requirements:
This device complies with Industry Canada’s license
exempt RSSs. Operation is subject to the following two
conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions
suivantes:
1) l’appareil ne doit pas produire de brouillage;
2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Cleaning
Remove battery before cleaning. Use a damp cloth and
mild detergent to clean the housing. Allow the housing to
dry fully before using.
Optional Equipment and Repair
CATALOG # DESCRIPTION
EK628-BC-HK Cutting Head Cover (52094931)
CJB Cutting Jaw
Disposal
Parts of these tools contain valuable materials and can be
recycled. There are companies that specialize in recycling
that may be found locally. Dispose of the components in
compliance with all applicable regulations. Contact your
local waste management authority for more information.
Service
• Tool service must be performed only by qualified
repair personnel. Service or maintenance
performed by unqualified personnel could result in
a risk of injury.
• When servicing a tool, use only identical
replacement parts. Use of unauthorized parts or
failure to follow maintenance instructions may
create a risk of electric shock or injury.]
Annually or after 10,000 cuts return tool for
service.
To Next Page
Loading...
Need help?
General
