To Next Page
R
raymondsimmonsAug 2, 2025
What to do if Greenlee Rotary Hammer does not punch hole?
- UumillerAug 2, 2025
If your Greenlee Rotary Hammer isn't punching holes, requires excessive force, or the pump isn't building pressure, several factors could be at play. First, check for improper assembly or misuse of the punch, die, or accessories, consulting the “Operation” and “Capacity and Draw Stud Selection Guide”. Next, ensure the oil level isn't low by checking “Adding Hydraulic Oil” in the “Maintenance” section. Also, verify that the material isn't too thick or hard by referring to the “Capacity and Draw Stud Selection Guide.” Finally, air in the system could be the culprit; address this by following step 3 of “Adding Hydraulic Oil” in the “Maintenance” section.
General
