To Next Page

To Previous Page

Setup & Operation

Initial Setup

Ideal Placement

There are several important factors to consider when selecting a location for your

GT3000:

• Make sure the location you choose is as far away from the HVAC air return duct

as possible. This will ensure that the purication produced by the GT3000 is

optimally circulated.

• Place the unit on top of something tall such as a bookcase, a shelf or a mounting

bracket, leaving only 12 to 24 inches between the unit and the ceiling.

• To ensure the unit works properly, there should be as much space as possible in

front of your GT3000 so that it can efciently process the air in the area.

• Never place an operating unit on the oor.

Initial Settings

Before using the unit you will need to nd the area (or square footage) of the

environment. To do this accurately, take into account all connected rooms with

open doorways (the purication does not ow readily through closed doors). The

GT3000 can purify up to 3,000 square feet of space.

For example: Suppose you have a 2500 square foot house. The living room is attached

to the kitchen, three bedrooms, the den and a laundry room. The kitchen and three

bedrooms’ doors remain open the majority of the time but the laundry room and den

usually remain closed off from the rest of the house. Together, the laundry room and

den have a combined area of 500 square feet. The area of the environment you would

want to set your GT3000 and purify would be 2000 square feet.

Once you have determined an ideal location for your unit and calculated the area

of the environment:

1. Connect the Power Cord to the Power Adapter and the Power Adapter Plug into the

unit. (Check to be sure your power supply is properly assembled. The Power

Cord should be inserted far enough into the Power Adapter so that a space of

only about 1/8 in. is left between the widest part of the power cord and the

edge of the Power Adapter.)

2. Insert the Power Plug into the wall outlet.

3. Turn the unit on and set it to NORMAL mode (see CONTROLS)

4. Leave the unit on NORMAL mode for at least 24 hours to begin with.

5. After 24 hours, set the unit to HIGH mode and set the square footage to

250 square feet.

6. Gradually increase the square footage setting every 8-12 hours until you

reach the accurate square footage of your area which you calculated in the

beginning steps). Note: Using the purier at a setting less than the square

footage of the area being treated is acceptable and may be desirable in an

environment relatively free of pollutants.

GreenTech GT3000 User Manual

Questions and Answers: