GreenTech GT3000 - Operating the Unit; Unit On;Off and Modes

13
Operating the Unit
Turning the Unit On/Off
Press the Power Button on the Control Panel or Remote to turn the unit on. The unit will initially be set to Normal Mode. Press the Power Button once more to turn the power off.
Using Normal Mode
Press Normal/High button until “Normal” is shown in the lower right of the Display.
• Square Footage not available in “Normal” (see “INITIAL SETUP: Initial Settings” page 12).
• To control the fan speed: Use Fan Up/Down buttons.
Using High Mode
Press the Normal/High button and verify that “High” is shown in the lower right of the Display.
• To set the square footage on the Display: Use Purier Up/Down buttons (See INITIAL SETUP: Initial Settings” page 12).
• To control the fan speed: Use Fan Up/Down buttons.
CAUTION: Never adjust setting to exceed square footage of ventilated space being treated.
Using Away Mode
Press the Away Mode button and verify that “Away” is shown in the lower right of the Display.
• To set the Away Mode Timer: press the Away Mode button. Each press of the Away Mode button adds two hours to the Away Mode Timer.
• Select 2:00, 4:00, 6:00 or 8:00 hours.
• Press Away Mode once more to switch the unit back to Normal Mode.