GreenTech pureAir 3000 User Manual

10
INITIAL SETTINGS
Before using your pureAir 3000 you will need to find the area (or square footage) of the
environment. To do this accurately, take into account all connected rooms with open
doorways (the cleaning does not flow through closed doors). The pureAir 3000 can
clean up to 3,000 square feet* of space.
*Based on average ceiling height of 8.5’ and open floor plan and/or adjoining rooms for
single level dwelling.
Once you have determined an ideal location for your unit and calculated the area of
the environment:
1. Connect the POWER CORD to the DC POWER ADAPTER and the DC POWER
ADAPTER PLUG into the unit. (Check to be sure your power supply is properly
assembled. The POWER CORD should be inserted far enough into the DC POWER
ADAPTER so that a space of only about 1/8 in. is left between the widest part of the
POWER CORD and the edge of the DC POWER ADAPTER.)
2. Insert the Power Plug into the wall outlet.
3. Turn the unit on and set it to NORMAL MODE (ARC) (see CONTROLS)
4. Leave the unit on NORMAL MODE (ARC) for at least 24 hours to begin with.
5. After 24 hours, set the unit to HIGH MODE and set the square footage to 250 square feet.
6. Gradually increase the square footage setting every 12 - 24 hours until you reach
the accurate square footage of your area which you calculated in the beginning
steps. Note: Using the unit at a setting less than the square footage of the area
being treated is acceptable and may be desirable in an environment relatively
free of pollutants.
7. If you reach your recommended square footage and still notice an unpleasant
odor from your space, consider using AWAY MODE for an extra cleaning boost.
(See page 11 for AWAY MODE instructions.)

GreenTech pureAir 3000 Specifications

General

Brand	GreenTech
Model	pureAir 3000
Category	Air Cleaner
Language	English