9
SETTING UP
This is going to be easy.
1. Unpack your pureAir 3000
Remove everything from the box. Check and make sure you have everything listed in
“PRODUCT CONTENTS” on page 2. Keep your packaging in case you need to return or
exchange your unit. When you are satised with your unit, please recycle the box and
properly dispose of all other packaging materials.
2. Select a location for your pureAir 3000
There are several things to consider when selecting a location. First, nd a common
room that contains an HVAC return or adjoining a hallway that has an HVAC return.
Ideally, locate the unit within twelve to twenty four inches (12”-24”) of the ceiling, on a
bookcase, shelf, or mounting bracket. Make sure that there is nothing within three inches
(3”) of the rear of the unit for proper air ow. Point the unit towards the center of the
room. Never place an operating unit on the oor.
3. Place your pureAir 3000 and plug it in
Check to make sure your unit is secure. Falling units can cause serious headaches! Unravel
the cord attached to your DC POWER ADAPTER and your POWER CORD. Plug the DC
POWER ADAPTER PLUG into the rear of the unit, then plug the POWER CORD into the wall.
Make sure the POWER CORD is securely seated in the DC POWER ADAPTER and that the
green indicator light on the DC POWER ADAPTER is lit, showing that it properly connected.
MAINTENANCE REMINDERS
“REPLACE CELL”
When “REPLACE CELL” appears, the ARC CELL has stopped functioning and must
be replaced. Contact your dealer or www.GreenTechEnv.com/Support to order a
replacement. Once a replacement has been obtained, follow the instructions in
“DISASSEMBLY” and “ASSEMBLY” (pages 12-15) to replace your old ARC CELL.
Note that the ARC CELL relies upon ultraviolet (UV) energy to power the catalytic
reaction. Over time, the UV energy output degrades. For this reason, the ARC CELL should
be replaced after one (1) year of continuous operation (9000 hours) regardless of the
presence of the “REPLACE CELL” maintenance reminder.
“PERFORM CLEANING”
“PERFORM CLEANING” will display once the unit has been run for 30 days total running time
and the unit requires a complete cleaning. Follow the instructions in “CLEANING” on page 16.
The unit should be powered OFF and the POWER CORD disconnected whenever
cleaning or servicing.
ARC Cell contains Hg (Mercury) and should be disposed of according to disposal laws.
Find disposal centers at www.earth911.org. DO NOT handle if broken or hot.
To Next Page
Loading...
