12
DISASSEMBLY
Tools Required
You will need a #2 Phillips screwdriver.
Workspace Recommendations
A counter top or flat surface is ideal for disassembling/assembling your unit. You will
need 2ft x 3ft of clean, accessible workspace. It is recommended to use a small bowl or
cup to hold any screws so they are not lost during the process.
Disassembly Instructions
1. Turn the unit off.
2. Remove the POWER CORD PLUG from the wall and the DC POWER ADAPTER PLUG
from the rear of the unit.
3. Clean exterior of unit if necessary (see “CLEANING” page 16).
Removing the REAR COVER:
1. Using your screw driver, remove the REAR COVER SCREW from the REAR COVER
(above the DC POWER ADAPTER INLET). Place the REAR COVER SCREW where you
will find it easily during reassembly.
2. Squeeze the sides of the REAR COVER until they release and tilt the REAR COVER
slightly upwards and pull directly away from the unit. Clean with compressed air or
a damp cloth. Set the REAR COVER aside.
Removing the FILTER ASSEMBLY:
1. Remove BRASS THUMBSCREWS from the top corners of the FILTER ASSEMBLY.
2. Place BRASS THUMBSCREWS where you will find them easily during reassembly.
3. Grasp the top of the FILTER ASSEMBLY and tilt away from the unit. Clean if necessary
(see “CLEANING” page 16) and set the FILTER ASSEMBLY aside. Lift FILTER ASSEMBLY
TABS on either side of FILTER ASSEMBLY to remove the rim and access the separate
honeycomb, foam, and mesh layers.
The unit should be powered OFF and the POWER CORD disconnected whenever
cleaning or servicing.
Refer to the Diagram Section (Pg. 5-6) for further illustrations of part names and locations.
To Next Page
Loading...
Need help?
General
