EasyManuals Logo

GreenTech pureAir 3000 User Manual

GreenTech pureAir 3000
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16
CLEANING
Your unit should be cleaned at least monthly to keep it running at peak performance, but more
often if its operating environment is heavily contaminated.
Cleaning the Unit (Exterior):
Wipe down the exterior with a damp cloth or use compressed air or a vacuum to remove dust.
Cleaning the FILTER ASSEMBLY
You may use clean water or compressed air to clean your FILTER ASSEMBLY once it has been
disassembled (see “DISASSEMBLY” on page 12). After disassembling your unit, the three lters
(mesh, foam, and honeycomb) should be removed and cleaned separately. If using water, you
must allow the lters to dry separately before reassembly. When reassembling, the Honeycomb
Filter goes in rst, then the Foam Filter, and nally the thin Mesh Filter. Lastly, reattach the rim to the
FILTER ASSEMBLY.
Cleaning the IONIZATION NEEDLE
Using a cotton swab, apply a small amount of clear alcohol-based cleaner (or rubbing alcohol)
to the IONIZATION NEEDLE. You may also use compressed air to blow off any dust that may
accumulate near the IONIZATION NEEDLE.
Cleaning the ARC CELL
Using a compressed air or a vacuum cleaner, blow and/or vacuum the dust out of the ARC CELL.
Do not use any liquid to clean the ARC CELL. Do not disassemble the ARC CELL.
Cleaning the PURIFICATION PLATE
Using white vinegar or a solution of equal parts warm water and clear ammonia, soak the
PURIFICATION PLATE for 8-10 hours but do not exceed 12 hours. Using a soft-bristle brush, scrub the
wire mesh to remove debris. Rinse thoroughly. Allow the PURIFICATION PLATE to dry completely
before reinstalling. Use a soft cloth and rubbing alcohol to clean the contacts on the interior of
the unit that touch the PURIFICATION PLATE.
Cleaning the Unit (Interior)
Using a damp cloth, a clear alcohol-based cleaner, compressed air or a vacuum cleaner,
carefully clean the walls and components inside of the unit only after completing the disassembly
procedures found in DISASSEMBLY on pages 12 - 13.
Resetting the “PERFORM CLEANING” Maintenance Reminder
To reset the “PERFORM CLEANING” maintenance reminder, press and hold the REMINDER RESET
BUTTON until the reminder goes away. It will return after 30 days of use.
The unit should be powered OFF and the POWER CORD disconnected whenever
cleaning or servicing.
Review the Disassembly and Assembly Section (Pg. 12-15) before performing and
cleaning and maintenance to prevent damage to the unit.
ARC Cell contains Hg (Mercury) and should be disposed of according to disposal laws.
Find disposal centers at www.earth911.org. DO NOT handle if broken or hot.
For proper operation, the unit should be cleaned at least once per month.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GreenTech pureAir 3000 and is the answer not in the manual?

GreenTech pureAir 3000 Specifications

General IconGeneral
BrandGreenTech
ModelpureAir 3000
CategoryAir Cleaner
LanguageEnglish

Related product manuals