14
Refer to “TOOLS & WORKSPACE” from “DISASSEMBLY” on Page 12
Installing the FRONT GRILLE:
1. Gently set the bottom of the FRONT GRILLE in place on the lower front of the unit
and swing the top of the FRONT GRILLE into place, being careful not to damage
the IONIZATION NEEDLE at the top center of the front of the unit.
2. Insert the two FRONT GRILLE SCREWS one at a time until they are in place, but not
tight. After both FRONT GRILLE SCREWS are in place, tighten them carefully.
Installing the ARC CELL:
1. Position the ARC CELL inside the unit so that the two tabs are on the bottom of the ARC
CELL. Ensure the holes in the two tabs t over the two screw posts. Screw the ARC CELL
RETAINING NUTS onto the screw posts until they are snug.
2. Align the ARC CELL CONNECTOR to the ARC CELL CONNECTOR outlet and insert gently
until the tabs at the top and bottom of the ARC CELL CONNECTOR snap into place,
holding it in the ARC CELL CONNECTOR outlet.
Installing the PURIFICATION PLATE:
1. Holding the PURIFICATION PLATE by the ceramic portion, slowly insert it into the
PURIFICATION PLATE slot, ensuring that the PURIFICATION PLATE is sliding into the
grooves on either side.
NOTE: About halfway in, the PURIFICATION PLATE connectors are parted. Continue
sliding the PURIFICATION PLATE into the PURIFICATION PLATE slot until there is
approximately one inch of the PURIFICATION PLATE remaining outside of the
PURIFICATION PLATE slot and significant resistance is met. Be careful not to force
the PURIFICATION PLATE further into the PURIFICATION PLATE slot as this could
seriously damage your unit.
ASSEMBLY
ARC Cell contains Hg (Mercury) and should be disposed of according to disposal laws.
Find disposal centers at www.earth911.org. DO NOT handle if broken or hot.
The unit should be powered OFF and the POWER CORD disconnected whenever
cleaning or servicing.
Refer to the Diagram Section (Pg. 5-6) for further illustrations of part names and locations.
To Next Page
Loading...
