What to do if grass winds around the trimmer head and motor housing of GreenWorks Pro Trimmer?
If grass is winding around the trimmer head and motor housing of your GreenWorks Pro Trimmer, it's likely due to cutting tall grass at ground level. To resolve this, cut tall grass from the top down, removing no more than 8" in each pass to prevent wrapping.
What to do if the line does not cut well on GreenWorks Pro UltraPower 60V ST60L03 Trimmer?
If the line on your GreenWorks Pro Trimmer isn't cutting well, the cut-off blade may have become dull. Sharpen the cut-off blade with a file or replace it.
Why GreenWorks Pro UltraPower 60V ST60L03 Trimmer does not start when I push the trigger?
If your GreenWorks Pro Trimmer doesn't start when you push the trigger, it could be due to a few reasons. First, check the electrical contact between the machine and the battery pack by removing the battery pack and reinstalling it. Another reason could be a depleted battery pack, so ensure it is fully charged. Lastly, make sure you are pulling the lock-out button and trigger at the same time. Pull and hold the lock-out button, then pull the trigger to start the machine.
What to do if the line does not advance on GreenWorks Pro UltraPower 60V ST60L03?
If the line on your GreenWorks Pro Trimmer isn't advancing, several issues could be the cause. If the lines are welded together, lubricate them with silicone spray. If there is not enough line on the spool, install more line. If the lines are worn too short, advance the cutting line. If the lines are tangled on the spool, remove them and rewind them.
Why the line keeps breaking on my GreenWorks Pro Trimmer?
The line on your GreenWorks Pro Trimmer might be breaking because of incorrect usage. To prevent this, cut with the tip of the line, avoiding stones, walls, and other hard objects. Additionally, advance the cutting line regularly to maintain a full cutting width.
Why vibration increases obviously on GreenWorks Pro UltraPower 60V ST60L03 Trimmer?
If the vibration on your GreenWorks Pro Trimmer increases noticeably, it might be because the line is worn down on one side and not advanced in time. Ensure the line on both sides is normal and advance the line.
What to do if GreenWorks Pro Trimmer stops when cutting?
If your GreenWorks Pro Trimmer stops while cutting, several factors could be the cause. First, ensure the guard is properly attached. Then, check the cutting line; use only nylon cutting line of 0.095" / 0.080" (2.4 mm / 2.0 mm) diameter. Also, grass winding around the motor shaft or trimmer head can cause this, so stop the machine, remove the battery pack, and clear any grass. Overloaded motor or overheating of the battery pack may be the reason. If the motor is overloaded, remove the trimmer head from the grass, and it should recover. When cutting, move the trimmer head in and out of the grass, removing no more than 8" in a pass. If the battery pack or machine is too hot, cool them down. Also, check if the battery pack is disconnected and, if so, reinstall it. Finally, ensure the battery...
General| Voltage | 60V |
|---|---|
| Battery Type | Lithium-ion |
| Line Diameter | 0.080 inches |
| Adjustable Handle | Yes |
| Variable Speed Trigger | Yes |
To Next Page