GreenWorks Pro ST60B00 User Manual (English)

Questions and Answers:

C
chavezdominicAug 5, 2025
How to fix a GreenWorks Pro ST60B00 Trimmer that fails to start?
- A
  amanda82Aug 5, 2025
  If your GreenWorks Pro Trimmer isn't starting, there are a few things to check: ensure the battery pack is properly attached to the trimmer. If it is, remove and reinstall the battery to ensure good electrical contact. Also, make sure the battery isn't depleted by charging it. Finally, confirm that you're pressing down the lock-off lever and holding it while depressing the trigger simultaneously.
C
chadjonesAug 10, 2025
What causes grass to wrap around the trimmer head of my GreenWorks Pro Trimmer?
- J
  Jasmine GreeneAug 11, 2025
  Grass wrapping around the trimmer head and motor housing of your GreenWorks Pro Trimmer is often caused by cutting tall grass at ground level. To prevent this, cut tall grass from the top down, removing no more than 8 inches in each pass.
S
Stacy CostaAug 15, 2025
What to do if the line is not cutting well on my GreenWorks Pro ST60B00 Trimmer?
- H
  Hannah JohnsonAug 15, 2025
  If the line on your GreenWorks Pro Trimmer isn't cutting well, the line-cutting blade on the edge of the guard may have become dull. Sharpen the blade with a file or replace it with a new one.
D
dtylerAug 20, 2025
Why does my GreenWorks Pro ST60B00 stop while cutting?
- W
  Wendy CollinsAug 20, 2025
  Your GreenWorks Pro Trimmer may stop while cutting due to several reasons. It could be that the guard is not mounted, leading to an overload because of a long cutting line. Other possible causes include using heavy cutting line (use only nylon cutting line 0.08" diameter or less), grass binding the motor shaft or trimmer head (stop the trimmer, remove the battery, and clear the grass), motor overload (remove the trimmer head from the grass to allow it to recover, and cut in smaller increments), the tool overheating (allow the battery pack and trimmer to cool), the battery pack disconnecting (reinstall it), or the battery depleting (charge it).
K
Kelsey WalkerAug 26, 2025
What to do if GreenWorks Pro ST60B00 line keeps breaking?
- A
  Andrew OchoaAug 26, 2025
  If the line on your GreenWorks Pro Trimmer keeps breaking, it might be due to incorrect usage. Ensure you're only trimming with the tip of the line and avoiding contact with hard objects like stones and walls. Regularly feed the line to maintain the full cutting width.
K
Katrina BrooksAug 30, 2025
Why won't the line advance on my GreenWorks Pro Trimmer?
- N
  nwilliamsAug 30, 2025
  If the line on your GreenWorks Pro Trimmer won't advance, it could be due to several reasons: the lines may be welded together (lubricate with silicone spray), there might not be enough line on the spool (install more line), the lines could be worn too short (pull both lines while pressing the button), or the lines are tangled on the spool (remove lines from spool and rewind).

GreenWorks Pro ST60B00 Specifications

General

Type	String Trimmer
Battery Voltage	60V
Line Diameter	0.080 inches
Run Time	Up to 45 minutes
Power Source	Battery
Battery Included	Yes
Charger Included	Yes
Adjustable Handle	Yes
Warranty	4 years
Cutting Width	16 inches
Cutting Swath	16 inches