12
Assembly and Adjustments
ASSEMBLY INSTRUCTIONS
The Electric Grass Trimmer must be assembled before use. The three parts of the
shaft must be connected and the guard must be attached.
Connect the handle to the motor housing (Fig. 2)
1. Slide the upper handle over the top of the middle handle, lining up the locking ball
with the hole on the upper handle. Push them together to lock.
2. Slide the middle handle over the top of the lower handle, lining up the locking ball
with the hole on the upper handle. Push them together to lock.
TO AVOID INJURY, ALWAYS TURN THE SWITCH OFF AND
DISCONNECT THE ELECTRIC GRASS TRIMMER FROM THE POWER OUTLET
BEFORE INSTALLING OR CHANGING THE TRIMMER LINE OR MAKING ANY
ADJUSTMENTS.
WARNING
Fig. 2
To Next Page
