13
Assembly and Adjustments
1. Invert the lawn trimmer to access the trimmer head (1).
2. Fit the guard (2) over the trimmer head and align the groove on the guard with the
tab on the motor housing (3).
3. Push the guard down over the tab, then turn it clockwise until the guard is
securely in place and the hole for the screw in the motor housing and guard are
aligned.
4. Insert the screw (4) into the guard and motor housing and tighten.
Install the guard (Fig. 3)
Fig. 3
2
4
1
3
(1) DOWN
To Next Page
