14
Assembly and Adjustments
WARNING
To avoid injury, always disconnect Electric Grass Trimmer from
the power supply before installing the guard, changing a cutting line, or making
any adjustments.
A spool of monofilament cutting line is preinstalled on the Electric Grass Trimmer. When
the cutting line needs replacing, insert a new spool.
To remove the spool:
1. Disconnect the Electric Grass Trimmer from the power supply.
2. Turn the Electric Grass Trimmer over to access the spool.
3. Remove spool cover by pressing on two tabs parallel to each other on the side of
the cover (2).
4. Remove the spool (1) from the spool housing (3).
To replace the spool:
1. Replace the spool (1) with a new pre-wound spool.
2. Insert the end of line through the opening (4) in the spool housing (3).
3. Align the tabs on the spool cover with the slots in the spool housing on the trimmer head.
4. Push down on the spool cover, locking it to the spool housing.
5. To advance the line when initially installed, you must pull the line while pressing
the black line release button on the side of the spool housing (3).
Fig. 4
Cutting Line (Fig. 4)
4
3
1
2
To Next Page
