GreenWorks 2540802 - Install the Mulch Plug; Unfold and Adjust the Handle; Install the Grass Catcher; Unpack the Machine

WARNING
Do not put in the safety key or the battery pack until
you assemble all the parts.
6.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
6.2 UNFOLD AND ADJUST THE
HANDLE
1. Pull up and back the upper handle to lift the handle
into operation position. Make sure that the handles
click into position correctly.
2. Tighten the upper handle with the cam locks on both
sides.
3. Tighten the lower handle with the cam locks on both
sides.
NOTE
Make sure that the two handles are in the same
position.
WARNING
Do not make damage to the cables when you fold or
unfold the handle.
6.3 INSTALL THE GRASS CATCHER
1. Remove the mulch plug.
2. Open the rear discharge door and hold it.
3. Hold the the grass catcher by its handle and engage
the hooks on the slots.
4. Close the rear discharge door.
6.4 INSTALL THE MULCH PLUG
1. Remove the grass catcher.
9
English
EN