OPERATION
STARTING AND STOPPING THE PRESSURE WASHER (See Figure 11.)
C A U T I O N :
Do not run the pump without the water supply connected and turned on.
Connect the garden hose.
Turn the garden hose on then squeeze the high pressure trigger to relieve air
pressure. Once a steady stream of water appears, release the trigger.
After ensuring the On/Off switch is in the OFF ( O ) position,connect the pressure
washer to the power supply.
NOTE: For ease of use during operation, you may thread the electrical cord through the coils of the
garden hose before connecting to power supply.
Press the reset button on the pressure washer’s plug to make sure the unit is
ready for operation.
Press ON ( I ) on the switch to start the motor.
To stop the motor, release the trigger and press OFF ( O ) on the switch.
W A R N I N G
Hold the handle and wand securely with both hands. Expect the trigger handle to move when
the trigger is pulled due to reaction forces. Failure to do so could cause loss of control and injury
to yourself and others.
NOTE: AUTO ON/OFF SWITCH: This Pressure washer is equipped with an Auto Start/Stop feature.
To operate: Press power switch On (I). Pump will pressurize and shut down immediately.Once the
trigger of the gun is depressed the unit will turn on. Unit will shut off and be in standby mode when
trigger is released.
Soap is applied under low pressure high volume for optimum performance. Soap cannot
be applied under high pressure with this machine.
18
To Next Page
Loading...
