OPERATION
USING THE SPRAY WAND TRIGGER (See Figure 12.)
For greater control and safety, keep both hands on the trigger handle at all times.
Pull back and hold the trigger to operate the pressure washer.
TO ENGAGE THE LOCK-OUT:
Push up on the lock-out until it clicks into the slot.
TO DISENGAGE THE LOCK-OUT:
Push the lock-out down and into its original position. For the most effective cleaning, the spray
nozzle should be between 8 in. and 24 in. from the surface to be cleaned. If the spray is too -
close it can damage the cleaning surface.
W A R N I N G
Do not slide lock-out button when you have the trigger at back position.
USING NOZZLE (See Figure 13.)
1-Pull back the quick-connect collar
2-Push the nozzle into place
3-Push the collar forward
NOTE:
19
To Next Page
Loading...
