GreenWorks CSA801 - Connect the Machine to the Power Supply; 10 Operation; Examine the Chain Oil; Hold the Machine

9.4 CONNECT THE MACHINE TO
THE POWER SUPPLY
NOTE
The machine has a cord retainer.
6
1. Form a loop at the end of the extension cord.
2. Put the loop portion of extension cord through opening at
the bottom of the rear handle.
3. Place over cord retainer.
4. Pull the loop against cord retainer until the slack is
removed.
5. Plug the machine into the extension cord.
10 OPERATION
WARNING
Before you plug in, examine if the rated mains voltage and
mains frequency, as tell on the rating label, match your
power supply.
WARNING
Before operation, examine if the mains connection cable
and extension cable have damage. Only use the mains
connection cables and extension cables in good condition.
IMPORTANT
Examine the chain tension before each use.
It is recommended to use the cord retainer in the rear handle
to prevent accidental disconnection of the power supply.
10.1 EXAMINE THE CHAIN OIL
NOTE
Do not use the machine without sufficient chain oil.
1. Examine the oil level of the machine from the oil
indicator.
2. Add the oil if it is necessary.
10.2 HOLD THE MACHINE
1. Hold the chainsaw with your right hand on the rear
handle and left hand on the front handle.
2. Hold the handles with the thumbs and the fingers around
them.
3. Make sure that your left hand holds the front handle and
your thumb is below the handle.
10.3 START THE MACHINE
4
3
1. Press the lock-out button (3).
2. Press the trigger (4) while you hold the lock-out button.
3. Release the lock-out button.
10.4 STOP THE MACHINE
1. Release the trigger to stop the machine.
10.5 FELL A TREE
23
24
24
25
25
Recommendation that the first-time user should, as a
minimum practice, start cutting logs on a saw-horse or cradle.
9
English
EN