GreenWorks CSF401 User Manual

1. Loose the chain cover by turning the chain cover
knob counterclockwise.
2. Remove the chain cover.
3. Put the chain drive links into the bar groove.
4. Put the chain cutters in the direction of the chain
operation.
5. Put the chain in position and make sure that the
loop is behind the guide bar.
6. Hold the chain and bar.
7. Put the chain loop around the sprocket.
8. Make sure the chain tension pin hole on the guide
bar fits correctly with the bolt.
9. Install the chain cover.
10. Tighten the chain. Refer to
Adjust the chain tension.
11. Tighten the chain cover knob when the chain is well
tensioned.
NOTE
If you start the chain saw with a new chain, have a test
for 2-3 minutes. A new chain gets longer after the first
use, examine the tension and tighten the chain if
necessary.
3.3 INSTALL THE BATTERY PACK
Figure 2
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.4 REMOVE THE BATTERY PACK
Figure 2
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
NOTE
Remove the battery pack and keep hands clear of the
lock out button when you move the machine.
IMPORTANT
Examine the chain tension before each use.
4.1 EXAMINE THE CHAIN
LUBRICATION
NOTE
Do not use the machine without sufficient chain
lubrication.
Figure 1
1. Examine the lubricant level of the chainsaw from the
oil indicator.
2. Add the lubricant if it is necessary.
4.2 HOLD THE MACHINE
Figure 8
1. Hold the chainsaw with your right hand at the rear
handle and left hand at the front handle.
2. Hold the handles with the thumbs and the fingers
around them.
3. Make sure that your left hand holds the front handle
and your thumb is below the handle.
4.3 START THE MACHINE
Figure 1
1. Press the on/off switch.
2. Press the lock-out button.
3. Press the trigger while you hold the lock-out button.
4. Release the lock-out button.
4.4 STOP THE MACHINE
Figure 1.
1. Release the trigger to stop the machine.
4.5 OPERATE THE CHAIN BRAKE
WARNING
Make sure that your hands are on the handles at all
times.
Figure 22
1. Start the machine.
2. Turn your left hand around the front handle to
engage the chain brake.
3. Pull the handle guard / chain brake toward the front
handle to disengage the chain brake.
4. Call approved service center for repair before use if
6
English
EN

GreenWorks CSF401 Specifications

General

Brand	GreenWorks
Model	CSF401
Category	Chainsaw
Language	English