GreenWorks STA806 - Cutting Tips; Change to the Edging Mode; Pivoting Head Function; Adjust the Length of the Shaft

9.6 CUTTING TIPS
• Tilt the machine toward the area to be cut. Use the
tip of the cutting line to cut grass.
• Move the machine from right to left to prevent
thrown debris from hitting the operator.
• Do not cut in the danger area.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood
can wear the cutting line quickly.
DIRECTION
OF
ROTATION
BEST CUTTING
AREA
DANGEROUS
CUTTING AREA
9.7 CHANGE TO THE EDGING MODE
NOTE
You can change the trimmer to an edger to keep
patios, driveways and sidewalks well groomed.
1. Stop the machine.
2. Push on the edge button (1) and turn the trimmer
head 90 degrees until the trimmer head locks into
position.
1
°90
3. Release the edge button.
9.8 PIVOTING HEAD FUNCTION
NOTE
Adjust pivoting head to trim areas which are hard to
reach and for users to operate comfortably.
1. Stop the machine.
2. Push on the pivoting button and turn the shaft until
the trimmer head locks into required position.
PRESS(1)
ADJUST(2)
3. Release the pivoting button.
9.9 ADJUST THE LENGTH OF THE
SHAFT
NOTE
You can adjust the length of the shaft to operate the
machine easily.
1. Stop the machine.
2. Unlock the cam lever and move the lower shaft to
the desired position.
3. Lock the cam lever.
9
English
EN