Connecting and disconnecting the gas cylinder
Parts and tools needed
• Gas cylinder
CommonPatio Gas cylinder, ll weight 5 or 13 kg, (e.g. green Propane Gas cylinder). These are available at DIY shops or
from liquid gas suppliers.
• Leak indicator
You can locate any leaks in the gas system using a leak detector. This can be purchased at DIY shops or liquid gas sup-
pliers. Please follow the operating instructions of the leak detector.
The following part is included in delivery. It corresponds to the standards applicable in the country to which it has been
supplied by LANDMANN.
Gas hose
-approved hose as per EN 4815-2 with sucient length, allowing installation without any kinks.
Pressure regulator
Preset pressure regulator tested as per EN12864, max. 1.5 kg/h, operating pressure 28-30/37 mbar, matching the gas
cylinder used. This type of pressure regulator is also commercially available.
Connecting the Gas Cylinder
Danger "Ignition of escaping gas"
Liquid gas is highly ammable and explosive.
Possible consequences:
• Serious personal injury or damage to property if escaping gas ignites in an environment
in which it is not controlled.
Safety precautions:
• When connecting the gas cylinder ensure that there are no sources of ignition within a
5 m radius.
• Take special care not to light any naked ames, do not smoke or switch on electric appli-
ances (devices, lights, door bells), etc. (sparkover possible).
• If necessary, replace the hose in order to comply with the corresponding national requi-
rements.
To Next Page
Loading...
