Climber 9.18/ Translation of the original instructions
– Check wiring of carburettor opening control
– Check petrol filter (and change if necessary)
– Check that the vent on the tank cap is not
blocked
– Fault in ignition system – Check that the caps of the spark plugs are
correctly fastened
– Check that the electrodes are clean and at the
correct distance apart.
Drop in engine performance during cutting
Speed too high for cutting height – Reduce speed
When the blades are engaged the engine cuts out
- Go ahead not given for blade engaging - Check the blade-engaging microswitch
- Sit in the driver's seat
Uneven cutting
– Cutting deck not parallel to ground – Check tyre pressure
– Level off the deck
– Blades fault – Check that the blades are correctly mounted
– Sharpen or change the blades
– Adjust the tension of the cutting deck
engine belt
Vibrations during operation
– Blades unbalanced – Balance blades or replace if damaged
– Fastenings are loose – Check and fasten the blade fixing screws
as well as the fixing screws of the engine
and chassis.
Incorrect P.T.O. engagement
– Check the battery voltage, it must be at least
12,5 volts
– Check the levelness of the blade brake
and the electromagnetic clutch, 0,3 mm
– When PTO button is pressed,
the blade does not engage
14
To Next Page
Loading...
