EasyManua.ls Logo

Grillo CLIMBER 9.18 - Troubleshooting and End-of-Use Procedures; Lubrication Points Guide; Troubleshooting Common Problems

Grillo CLIMBER 9.18
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Climber 9.18/ Translation of the original instructions
LUBRICATION POINTS WITH GREASE
TROUBLESHOOTING
PROBLEM
CAUSE REMEDY
Dashboard OFF with key in “AVV.” (ON) pos.
Battery not supplying power – Check connecting cables
– Check electrolyte level
– Recharge battery
– Change the fuse
Dashboard ON, but starter motor does not turn over with key in “AVV” (ON) pos.
– Battery not supplying enough power – Recharge battery
– Start-up go-ahead not given – Travel lever in stop position
– Disengage blades
– Sit in the driver’s seat
Difficult starting or irregular running of engine
– Carburettor problems – Clean or change the air filter
Adjust the carburettor (follow engine manual
instructions)
– Deposits or dirt in fuel – Empty the tank and use fresh petrol
– Check and change the petrol filter if necessary
Starter motor turns over but engine does not start
– No petrol flow Check that the choke has been activated (if
engine is cold)
– Check petrol level in tank
13

Related product manuals