Baserunner Controller User Manual
Rev 1.0
3.3 Headless System
Finally, the Baserunner can be run with only a PAS / Torque sensor wired up to
the 6 pin PAS plug, or just a throttle on the Mains plug. In this arrangement, it is
essential to wire up the on/off power switch on either the WP8 plug or the Mains
connector for the controller to turn on.
There is limited ability to modulate the PAS power assist level in this minimal
approach as the controller does not have a native input for increasing or
decreasing the PAS power adjustment without reprogramming. For a basic PAS
controlled ebike most people would still want a small communicating display
device that provides up/down power adjustment.
-8-
To Next Page
Loading...
Need help?
General