25
Specications are subject to change without prior notication December 2019
11 Storage
Wash the machine
To properly check the machine it must be
clean. After washing, lower the machine on to
the tines and retract all hydraulic cyclinders.
This will protect the ram shafts and make it
possible to check any bearings if tted.
Grease and check
Greasing the machine after washing will purge
any water from pins etc. See Section 12 for
more details.
Check bearings, pivots, pins etc. for wear.
Retract all cylinders to protect shafts from
rusting, this will ensure there is no weight left
on the tyres.
Order parts
This is a good time to forward order any
replacement parts you will need for next year,
Some components are imported and may
have long delivery times
When ordering parts quote the serial number
of the machine, this is on the identication
plate located on the front of the machine, and
the part number of the parts from the parts
section of this manual.
To Next Page
Loading...
Need help?
General